Igloo MWC529 Manuel D'utilisation page 3

GETTING TO KNOW YOUR WATER DISPENSER
Cooling tank for the cold water, made of stainless steel.
For the hot water there is a stainless steel heavy duty hot water tanks with
an external heater. It is suitable for mineral water.
Thermostat on the rear panel.
Two switches on the rear panel : one for the hot water, one for the cold water.
All water ways are made from stainless steel
Refrigeration compressor is quiet and durable.
The power cord has a grounded plug. Please make sure that your outlet
is properly grounded.
Integrated No-Spill system for added hygiene and convenience.
There are two high-flow taps on the front. The tap handles are color-coded.
Red is for hot, blue for cold water.
The hot water tap handle has a child resistant hot water guard. To operate it, squeeze
the handle and locking device together and then push them down
Easy to clean deep drip tray
PREPARING YOU WATER DISPENSER
1- Make sure that the water dispenser is not plugged into the electrical outlet.
2- Hold the water bottle vertically and upside down and place the water bottle
into the no-spill bottle receptacle. Apply slight pressure in order to pierce the
bottle cap with the spigot. It is no advisable to make any adjustments to the
thermostat setting before the water dispenser and bottled water are warmed
up to normal room temperature. This unit accepts two, three or five gallon
water bottles.
3- Open the two taps to let air out , until the water starts to flow. When
this happens, release the buttons.
4- Plug the water dispenser into a grounded power outlet and turn the
power switches on.
5- If the water dispenser is brought in from outside in the winter time, give it
few hours to warm up to room temperature before plugging it in. The
thermostat setting may be affected by coldness of the water dispenser itself
or the bottled water.
- The refrigeration thermostat is factory set between 7°C and 8°C (44.6°F and 46.4° F).
- The hot water thermostat is factory set between 88°C adn 89°C (190.4°F and 192.1°F).
- Before the water dispenser leaves the factory, the thermostat is set properly. It is not advisable to adjust
the thermostat when using the water dispenser.
NOTE :
When your water dispense is in operation there is a small amount of water in the water passage between
the water tanks and the taps.This water is not controlled by the cold or hot temperature settings. We recom-
mend that in order to fully enjoy the desired water setting, you should eliminate this small amount , 200ml
- 400ml (6.76 fl .oz-13.52 fl .oz) using a small glass container.
2
▌
▼
PLACE
BOTTLE
VERTICALLY
STRAIGHT