Télécharger Imprimer la page

Zephyr PRW24C02ABSG Guide D'utilisation, D'entretien Et D'installation page 10

Refroidisseur de vin à deux zones preserv, acier inoxydable noir

Publicité

Les langues disponibles

Les langues disponibles

LEVELING:
The wine cooler should be installed on a rm and level surface that will be able to support the
e
e weight of a fully loaded unit. It is important for the wine cooler to be leveled in order to
work properly. It can be raised or lowered by rota
of the machine. If you
cooler becomes level. You may need to make several adjustments to level it. We recommend using a
carpenter's level to check the machine. Turn the leveling feet to the right to lower that side of the
cooler. Turn the leveling feet to the le to raise that side of the cooler.
RECOMMENDED GROUNDING METHOD:
For your personal safety, this appliance must be grounded. It is equipped with a power supply cord having a
3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a ma
pronged wall socket, and grounded in accordance with the N
ordinances. If a ma
properly grounded, 3-prong wall receptacle installed by a quali ed electrician.
Electrical Shock Hazard!
Plug into a grounded 3-prong outlet.
Never remove the grounding prong from the plug.
Never use an adapter to bypass the grounding prong.
DO NOT use an extension cord.
Failure to follow these instr
Before you move your wine cooler into its
proper electrical
with the N
Electrical Code and local codes and ordinances, is required. It is recommended that a
separate circuit, serving only your wine refrigerator, be provided. Use receptacles that cannot be
turned
by a switch or pull chain.
The fuse (or circuit breaker) size should be 15 Amps.
Installing Your Door Handle and Shelves
INSTALLING THE DOOR HANDLE:
1. Open the door and carefully pull the door gasket around the area where the handle is to be installed.
2. Insert each Phillips head screw through the gasket side of the door un l the screw passes through the
door.
3. Align the handle with the screws and ghten using a Phillips head screwdriver
against the door frame.
Do not over- ghten the screws as this may cause damage to the handle or to the stainless steel
door.
4. Carefully press the door gasket into its original
that the surface is not level, rotate the feet
wall socket is not available, it is the personal responsibility of the customer to have a
can result in re, electrical shock, or personal injury.
A standard electrical supply (115 V, 60Hz), properly grounded in accordance
the
sheaths around each of the feet on the
Electrical Code and local codes and
it is important to make sure you have the
5
the wine
3-
the handle is

Publicité

loading