Publicité
Les langues disponibles
Les langues disponibles
SECTION 8
Finishing the Installation
1.
Reinstall the bottom cover removed in Section 1 using the 4 screws to secure it in place.
2.
Reinstall the filters by fitting them into the channel on either side of the hood and
pushing upwards on them until they are secured in place (Figure 11).
Figure 11
3.
Install PAR16 medium base 45W maximum Halogen lamps (not included).
4.
Turn switches to the "OFF" position and restore power. Test that the light and the fan are
operating properly.
5.
If there is any vibration noise, check for the source and try to tighten fasteners or adjust
the tape to make a tighter connection or seal.
SECTION 9
Controls
Your Range Hood is equipped with two rocker style switches with one controlling the lighting
and the other controlling the exhaust fan. The light switch has two positions, On ( • ) and OFF
°
(
). The fan switch has three positions, High ( • • ), Low ( • ), and OFF (
Trouble
1. Hood does not operate when the switch is on.
2. Hood is operating, but air moves slower than normal.
3. Hood is making a rattling noise.
Installer:
Place of Purchase:
5085462 New 2-12
All manuals and user guides at all-guides.com
Channel
°
).
Troubleshooting Guide
Probable Cause
1a.
A fuse may be blown or a circuit tripped.
1b.
Wiring is not connected properly.
2.
Obstruction in the exhaust ducting.
3a.
Filters are loose.
3b.
Duct connection is loose.
SECTION 10
Maintenance
CAUTION:
SERVICING THE UNIT.
Filters
1.
Grease Filter - Included with your range hood are aluminum grease filters that should
be washed at least once a month. The filters are dishwasher safe and should be washed
in a mild soap or detergent. Reverse the instructions in the "Finishing the Installation"
section of the instructions to remove filters. If the grease filters become damaged,
replace with Air King Model GF-01 Grease Filters.
Changing the Lamp
1.
Unscrew the lamp by turning in a counter-clockwise direction and remove from the
socket. Replace with a PAR16 medium base 45W maximum Halogen lamp. Installation is
the reverse of removal.
Fuse
1.
To replace the fuse, turn the fuse cap located next to the wire connector counter
clockwise and pull out. Replace with only a 125-Volt fuse, 3 Amp Max. Reinstall the fuse
back into the hood (Figure 7).
Cleaning
CAUTION:
ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1.
Clean your range hood with a mild detergent, such as dishwashing liquid, and dry with a
soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry
before restoring power. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
2.
The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over time.
The fan is permanently lubricated and does not require oiling.
1a.
1b. Turn off power to unit. Check that all wires are connected.
2.
3a.
3b. Turn off power to unit. Check that duct connection is tight.
Installation Date:
Model Number:
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH CLEANSERS,
Suggested Remedy
Replace fuse or reset circuit breaker.
Check for any obstructions in the ducting including filter.
Turn off power to unit. Check that all filter are securely in place.
4 of 12
Publicité
