Intel Express 300T Stackable Hub Démarrage Rapide page 3

Optional Information
4
Stack the Hubs
• Unplug the power cords from all the hubs.
• Use the included cascade cable to connect the
hubs. Hubs can be stacked up to five high
(mixed 16- or 24-port).
• When properly connected, the entire stack will
act as a single repeater with two segments
(10Mbps and 100Mbps). The top hub in a stack
will be numbered hub 1.
• The hub's internal bridge automatically bridges
the 10Mbps and 100Mbps segments (collision
domains) for the entire stack.
Changing MDI/MDI-X
5
for Port 1
• All ports on the hub are MDI-X. Pressing the
MDI/MDI-X button switches Port 1 to MDI so
you can connect to another hub or switch using
a straight-through cable.
• Because the 330T is a Class II hub, never
daisy-chain a 330T hub to a Class I hub running
at 100Mbps with UTP cable. Doing so can lead
to poor network performance.
6 Add Optional Modules
• Both 16- and 24-port 330T hubs can accept
optional modules (refer to the User Guide).
• Use optional modules to manage a stack,
connect to devices at full duplex, or to extend
the network to another building or beyond
100 meters.
Hub 1
Module A
Hub 2
Module A
Hub 3
Module A
Cascade Cable
Stacking Hubs: The cascade cable
connects from the "Down" connector
on one hub to the "Up" connector on
the hub below it.
®
Intel
MDI
1
MDI-X
Class II
MDI/MDI-X
button
®
Intel Express 300 Series
Crossover
Ethernet Module
MDI
MDI-X
®
Intel Express 300 Series Fiber Module
Duplex
TX RX
EIA 232
009027390005
MAC Address
Console: 9600-8-N-1
Management Module for Express 330T Hubs (EE300MM)
Up
Down
Cascade
Up
Down
Cascade
Up
Down
Cascade
Express 330T Stackabl
2 3 4
MDI
MDI-X
Ethernet Module for
Express 330T Hubs
(EE300EM)
Fiber Module for
Express 330T Hubs
Half
(EE300FX)
Full
®
Intel Express 300 Series
Management Module
2