Publicité
Installation / Installation / Instalación
Step 1 – Preparing the countertop
Place the template (B) on the countertop. Ensure the template is
centered on the counter so that it is parallel to the counter edge
and that the installation hole will not interfere with the structure
of the cabinet.
Tape the template (B) to the countertop to keep it in place and
trace the cutout line on the template (B) with a pencil.
Step 3 – Drilling holes for the clips
On the underside of the counter, mark the location of the twelve
holes for the clips. These holes should be equally spaced around
the perimeter of the cutout.
Using an electric drill with a 11 mm drill bit, drill each hole so
that it is 11 mm in diameter and 14 mm deep.
Insert the plastic caps from each of the clips into each of the
installation holes.
Step 2 – Cutting the installation hole
Drill a pilot hole and cut the countertop opening. Use the appropriate
cutting tool for the surface you are cutting and cut along the inside of
the template line.
Step 4 – Installing the sink
Insert the screws (1) loosely in the holes that you drilled in the
underside of the counter. Ensure that you use the clips in the locations
that have the narrowest clearance between the sink and counter.
Place a small bead of silicone sealant (not included) around the upper
lip of the sink (A).
Carefully place the sink (A) into its location under the counter, with the
lip of the sink being supported by the clips (AA).
Tighten the screws (1) evenly, ensuring the sink (A) remains in place.
Wipe away any excess silicone and, for best results, allow the bond to
rest undisturbed for 8 hours or overnight.
Undermount
Stainless
Steel Sinks
Revised
3/20/2020
Publicité
