Publicité
Les langues disponibles
Les langues disponibles
self or your clothes which can ig nite. Wash
your skin and change clothes im me di ately.
a) Use only an ap proved g a s o line con -
tainer.
b) Never fill con tain ers in side a ve hi cle or
on a truck or trailer bed with a plas tic
liner. Al ways place con tain ers on the
ground away from your ve hi cle be fore
fill ing.
c) When prac ti cal, re move gas-pow ered
equip ment from the truck or trailer and
re fuel it on the ground. If this is not pos -
si ble, then re fuel such equip ment o n a
trailer with a por ta ble con tainer, rather
than from a gas o line dis penser noz zle.
d) Keep the noz zle in con tact with the rim
of the fuel tank or con tainer open ing at
all times un til fuel ing is com plete. Do not
use a noz zle lock-open de vice.
e) Ex tin guish all cig a rettes, ci gars, pipes
and other sources of ig ni tion.
f) Never fuel ma chine in doors.
g) Never re move gas cap or add fuel while
the en gine is hot or run ning. Al low en -
gine to cool at least two min utes be fore
re fu el ing.
h) Never over fill fuel tank. Fill tank to no
more than ½ inch be low bot tom of filler
neck to pro vide space for fuel ex pan -
sion.
I) Re place gas o line cap and tighten se -
curely.
j) If gas o line is spilled, wipe it off the en gine
and equip ment. Move unit to an other
area. Wait 5 min utes be fore start ing the
en gine.
k) Never store the ma chine or fuel con tainer
in side where there is an open flame,
spark or pi lot light as on a wa ter heater,
space heater, fur nace, clothes dryer or
other gas ap pli ances.
l) To re duce fire haz ard, keep ma chine free
of grass, leaves, or other de b r i s
build-up. Clean up oil or fuel spill age
and re move any fuel soaked de bris.
m) Al low ma chine to cool at least 5 min utes
be fore stor ing.
GEN ERAL SER VICE:
Never run an en gine in doors or in a poorly
•
ven ti lated area. En gine ex haust con tains car -
bon mon ox ide, an odor less and deadly gas.
Be fore clean ing, re pair ing, or in spect ing,
•
make cer tain the blade and all mov ing parts
have stopped. Dis con nect the spark plug
wire and ground against the en gine to pre -
vent un in tended start ing.
Check the blade and en gine mount ing bolts
•
at fre quent in ter vals for proper tight ness.
Also, vi su ally in spect blade for dam a g e
(e.g., bent, cracked, worn) Re place blade
with the orig i nal equip ment man u fac turer's
(O.E.M.) blade only, listed in this man ual.
"Use of parts which do not meet the orig i nal
equip ment spec i fi ca tions may lead to im -
proper per f o r m a n c e and com p r o m i s e
safety!"
Mower blades are sharp and can cut. Wrap
•
the blade(s) or wear gloves, and use ex tra
cau tion when ser vic ing them.
Keep all nuts, bolts, and screws tight to be
•
sure the equip ment is in safe work ing con -
di tion.
Never tam per with safety de vices. Check
•
their proper op er a tion reg u larly.
Af ter strik ing a for eign ob ject, stop the en -
•
gine, dis con nect the spark plug wire and
ground against the en gine. Thor oughly in -
spect the mower for any dam age. Re pair
the dam age be fore start ing and op er at ing
the mower.
Grass catcher com po nents, d i s charge
•
cover, and trail shield are sub ject to wear
and dam age which could ex pose mov ing
parts or al low ob jects to be thrown. For
safety pro tec tion, fre quently check com po -
nents and re place im me di ately with orig i nal
equip ment man u fac turer's (O.E.M.) parts
only, listed in this man ual. "Use of parts
which do not meet the orig i nal equip ment
spec i fi ca tions may lead to im proper per for -
mance and com pro mise safety!"
Do not change the en gine gov er nor set ting
•
or overspeed the en gine. The gov er nor con -
trols the max i mum safe op er at ing speed of
the en gine.
Main tain or re place safety and in struc tion la -
•
bels, as nec es sary.
Ob serve proper dis posal laws and reg u la -
•
tions. Im proper dis posal of flu ids a n d
ma te ri als can harm the en vi ron ment.
5
SI-102
1.17.02
Publicité
