LSC Smart Connect Démarrage page 5

EN
Getting Started
Before you start adding this LSC Smart Connect product, write down the name and
password, including spaces and capital letters, of your WiFi network. Make sure you have a
strong WiFi signal.
Note: This item only works on 2.4GHz WiFi network, not on 5GHz WiFi network. If you get a
message that the product only works on 2.4 GHz networks, then you need to change your
network's WiFi frequency to 2.4 GHz in the settings menu of the router. Please contact
your internet provider for this.
Installing the battery and the micro SD memory card (optional)
Open the battery compartment and insert the batteries as indicated inside the
compartment. Insert a MicroSD card (optional). Close the compartment
The device will power on automatically as soon as the batteries are installed. Note: the
batteries are not fully charged. Charge the batteries using a 5V1A adapter. A full charge
will take 9 hours. The charging indicator near the USB port is red while charging, and will
turn o automatically once fully charged
The camera will enter standby mode when it has been idle for more than 15 seconds.
Setting up the LSC Smart Connect app & adding the doorbell
1. Download the LSC Smart Connect app from the Google Play Store, the Apple Store or scan
the QR code.
2. Open the app. Are you using the app for the first time? Then follow the instructions on the
screen to create your account.
3. Click on "+" shown in the upper right corner or "Add Device" and select the device among
the list of products.
Turn the device on. You do this by inserting the batteries. You will hear a voice the device is
waiting for the QR code to be scanned. (The device is now in pairing mode.)
Input the WiFi password and click "Confirm". Scan the QR Code that appears in the app
with the camera of the device. Hold the QR code steady at 10-15 cm in front of the camera.
When the device makes a sound, follow the on-screen instructions. The set-up will be
completed automatically. For more information, see our website: www.lsc-smartconnect.com
4. Reset: You may need to reset the product first. Locate the reset button and press it inuntil
you hear the voice say "System reset" (about 3 seconds). The blue indicator LED will start
blinking. Then proceed with step 3.
Setting up the chime unit & pairing chime to doorbell
Pairing: Plug-in the chime, press and hold button ② for 3 seconds until the blue indicator
lights up. Then ring the video doorbell, the indicator of the chime flashes, which means that
pairing was successful.
Change tones and pairing: Press button ① or ③ to cycle through the tones and select the
desired one. Press and hold button ② for 3 seconds until the blue indicator lights up. Then
ring the video doorbell, the indicator of the chime flashes, which means that changing the
tone was successful.
Change the volume: Press button ② to change the volume of the chime.
Unpairing: Hold and press ② then plug-in the chime, do not release the button until the
blue indicator lights up.
Installation of the the doorbell
Install the doorbell using the screws and plugs suitable for the intended surface. Use the
live preview on your phone to determine the best height and location.
Charging: Connect the doorbell to an external power source via the supplied charging
cable. While charging, you can view the charging status in the app. If you prefer to use a
power adapter (adapter is not included), the power adapter specification is 5V/1.5A.