Horizon Global 76253 Instructions D'installation page 4

1. Remove Fascia – Remove the 6 plastic expanding fasteners using a screwdriver from the bottom of the fascia. Remove 2 screws from each wheel well using a phillips
screwdriver to remove splash guards. Remove 1 plastic expanding fastener from under each splash guard. Remove 1 plastic push rivet from each wheel well by using the
tip of a screwdriver to push the center of the pin in. Open the liftgate, remove panel near taillight to expose screw that connect the fascia to the vehicle body with a 10mm
socket, 1 each side. Starting from the wheel well gently pull off fascia. Unplug any wires that are attached.
2. Remove bumper – Use pry tool to remove wire harness from the top of the
bumper, one each side. Remove 3 M10 bolts and 1 M10 flangenut with a 17mm
socket from each side, set nuts aside for re-attachment, 2 each side. Return the
bumper and bolts to the vehicle owner.
©2018 Horizon Global Americas Inc. - Printed in Mexico
3. Install hitch – Raise the hitch into position over the bumper studs, install the
nuts removed earlier. Install the supplied M10 bolts and conical washers (teeth
side toward hitch) into remaining weldnuts each side. Attach the wire harnesses
to the top of the hitch brackets and zip tie into place.
Sheet 4 of 15 76253NP 8-8-18 Rev. A