Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT: Do not use the
clipper in this mode for more than
20 minutes.
Replacement (removal) of blade
set
1/ Unplug the unit and adjust the
taper (see illustration A).
2/ Remove the screws and the
fixed blade. Save the screws.
3/ Lift off the small moving blade
and replace it with the new one
on the plastic oscillator (see
illustration B).
A.
Taper
4/ Replace the fixed blade using
the screws and lightly tighten
them. Adjust the teeth as shown
in illustration C, to a gap of 1mm
to 1.5mm and the small, moving
blade as centered and parallel as
possible to the fixed blade's teeth.
C.
Fixed blade
C.
Small`
Moving
Blade
IMPORTANT NOTE:
Be sure to add a few drops of
BaBylissPRO lubricating oil to the
blades before running.
Plastic
B.
Oscillator
Small
Moving
Blade
1mm to
Don't forget to tighten the screws
after the blades have been
aligned.
Cleaning & Maintenance
• To
performance,
should be cleaned after each use.
• Blow away any remaining hair on
the blades or use the cleaning
brush provided.
• Remove the comb guide. The
comb guide can be rinsed under
running water. Ensure they are
dried thoroughly before storage
or further use.
• Oil the blades after every use
to ensure optimum cutting
performance.
CONTAINS LITHIUM ION
BATTERY. MUST BE COLLECTED,
RECYCLED OR DISPOSED OF
PROPERLY. DO NOT DISPOSE OF
IN THE GARBAGE.
1.5mm
7
maintain
the
optimum
appliance
Publicité
