Publicité
Les langues disponibles
Les langues disponibles
Casting Side Panels
1. On the casting side panels, release the top and
bottom screws.
2. Drop a hinge pin on the back corner of base and
drop the side panel on the pin.
3. Rotate the panel towards the engine.
2
3
4. Repeat with the other casting side panel.
Fixing Casting Side Panels & Engine
1. Adjust the position of the engine to locate the top
and bottom screws of the side panels into the
slots of the engine's side bracket. Tighten the top
and bottom screws.
6
All manuals and user guides at all-guides.com
2. Adjust the engine as required and fi x it to the
Top Spar
1. Position the top spar on the side brackets located
2. Fix the spar with two 3/8" pre-assembled screws
Complete engine installation
Refer to the engine installation manual for the following
steps.
1. Reposition the lighting instructions plate, remote
2. Install the fan, if used, and convert the top outlet to
3. Install venting system.
4. Connect the gas and install the logs.
5. Refi t the window and the hot glass warning plate.
6. Set up the remote control and check operation.
Front Installation
Hook the cast front to the side brackets located
between the engine
and the cast sides.
Details
casting base at bottom of its side brackets with the
nuts and bolts provided.
between the engine and the cast sides.
provided.
control receiver and connect gas line to the inlet
pipe.
a rear outlet or co-linear outlet if necessary.
Hook
Cast front
Engine
Side bracket
Publicité
