Valor MADRONA MFCS01 Instructions D'installation page 4

Casting Tolerances
Due to the nature of cast iron and concrete, dimen-
sional consistency may vary from one unit to the
next and some variation in surface fi nish and fl at-
ness is to be expected. We have done our best to
control and make allowance for this; however some
variation is inevitable.
Floor Requirements
The Madrona heater is approved for installation
directly on any combustible material other than soft
fl ooring material such as carpet or vinyl.
Mobile Home Floor Fixing
The Madrona stove must be fi xed to the fl oor
through the fl oor when used in a mobile home.
Mantel Requirements
The Madrona stove may be installed with a
combustible mantel provided clearances are
maintained as indicated above. Be aware that
although safe, some combustible materials and
fi nishes at the listed clearances may, over time,
discolor, warp, or show cracks. Care should be
taken when choosing materials—consult your
fi replace dealer.
Installation
Unpack the appliance and stove casing
The Madrona engine is supplied separately from the
stove casings. The Traditional stove—MFCS01 (black)
or MFCS02 (majolica brown)—and the Contemporary
stove MFCS04 are each supplied in two cartons. You
must have in hand the stove casing before starting the
assembly of the appliance.
Unpack the carton carefully. We strongly recommend
that you leave the engine sitting on the packaging
base in which it came to avoid damaging the
control valve, wires and pipes already attached
to the engine until it is ready to insert in the stove
casing.
Some parts are packed in the cardboard sleeve around
the engine; make sure you take them all out of the
packaging. Make sure you have all the components
including the stove casing components before you start
the installation.
4
All manuals and user guides at all-guides.com
CAUTION
LEAVE THE ENGINE ON ITS PACKAGING
BASE to avoid damage to the control valve,
wires and pipes until ready to insert into
stove casing.