Mondovino Avantgarde MVBD45DFS Manuel D'instructions page 16

2. INSTALLATION INSTRUCTIONS
INSTALLATION SPECIFICATIONS
This appliance requires a standard 115 Volt A.C. /50Hz electrical outlet with three-prong ground
•
This appliance is designed to be installed built-in or free standing.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
•
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient
temperature below 59°F (15°C) or above 77°F (25°C) will hinder the performance of this appliance. This
unit is not designed for use in a garage or any other outside installation.
Avoid locating the appliance in moist areas.
•
Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized Service
Center. This unit is not designed to be installed in an RV or used with an inverter.
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 ~ 4 hours before placing
•
wine bottles in the appliance.
This wine cooler come with adjustable legs to help level the unit
•
BUILT-IN INSTALLATION
The cutout dimension illustrated (see below) allows for door swing and access to the pull-out shelves when
installed as a built-in appliance. If installing between frameless cabinets, a ¼" wide filler strip or side panel
may be needed on the hinge side. The filler strip will act as a spacer between the appliance case and
adjacent cabinet door swing. The width of the opening must include the filter panels.
Note:
The door should protrude at least 1" beyond the surrounding cabinets.
"
24
Model MVBD45DFS
16
。