Publicité
Les langues disponibles
Les langues disponibles
The tool won't crimp when I press the trigger.
The InteLED flashes red when I activate the tool.
At the end of the crimp cycle, Inteled flashes red and then
flashes green for good crimp and then InteLED lights up
white.
Before the automatic switch off of the tool, InteLED flashes
white during 10 seconds, red during 1 second and the
tool switches off.
The tool repeatedly give me bad crimps / The InteLED
flashes red after every crimp.
The tool is leaking hydraulic oil.
12 ► BP130 User Manual
TROUBLESHOOTING
Problem
Ensure the battery is charged. Disengage the trigger
lock.
The maintenance interval is about to elapse. Have the
tool serviced as soon as possible.
The maintenance is achieved. Have the tool serviced
immediately.
Ensure the battery is fully charged. Ensure the dies
are inserted properly into the crimping head. If problem
persists, have the tool serviced as soon as possible.
Have the tool serviced immediately.
Solution
Publicité
