Fellowes POWERSHRED 325Ci Mode D'emploi page 4

PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
TO CLEAN THE SENSORS
1 2
Locate Auto-start
shredder infrared sensor
OILING SHREDDER
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Remove Paper Indicator: When illuminated, press reverse (
Straight Feed Indicator: When illuminated, remove paper and feed straight into paper entry.
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
4
.
3 4
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
ENGLISH
Models 325Ci/325i
®