Danby DCRD042C1BSSDB Manuel Du Propriétaire page 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the hinge cover and upper hinge from
the top right side of the cabinet. Remove the
screw hole cover from the top left side of the
cabinet.
2. Remove the freezer door from the cabinet. Move
the hinge plug from the top left to the top right
side of the door.
3. Remove the center hinge from the right side
cabinet. Remove the screw hole covers from the
left side of the cabinet.
4. Remove the refrigerator door from the cabinet.
Move the hinge plug from the top left to the top
right side of the door.
5. Remove the door stop from the lower right side
of the refrigerator door. Install the door stop on
the lower left side of the refrigerator door.
6. Remove the lower hinge from the bottom right
side of the cabinet. Remove both adjustable feet.
Remove the lower hinge pin from the hinge, fl ip
the hinge over and reinstall the hinge pin on the
other side. Install the lower hinge on the bottom
left side of the cabinet. Install both adjustable
feet.
7. Install the refrigerator door. Install the center
hinge on the left side of the cabinet. Install
the screw hole covers on the right side of the
cabinet.
8. Install the freezer door. Install the upper hinge
and the hinge cover on the top left side of the
cabinet. Install the screw hole cover on the top
right side of the cabinet.
Note: Ensure the rubber gaskets are making a good
seal with the cabinet all the way around the doors
before tightening the hinge screws.
1
2
3
4
6
7
5
5
8