EMERGENCY BATTERY BACKUP
FOR LED SQUARE CANOPY LIGHTS
Models: 65/150
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• To reduce the risk of personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other
hazards read all warnings and instructions included.
• Before installing, servicing or performing routine maintenance on this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaries should be performed by a qualified licensed electrician.
If you are unsure about the installation or maintenance of the luminaries, consult a qualified licensed electrician and check
your local electrical code.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• Turn OFF electrical power at fuse or circuit breaker before wiring fixture to the power supply.
• All connections should be capped with UL approved
wire connectors.
• Keep away from any corrosive substance.
• Use a dry cloth when cleaning fixture.
• Not suitable for use in wet locations.
INSTALLATION
1
Put the sealing rings on both ends of the connector.
Sealing Rings
3
Remove the end cap from the fixture body, assemble
the fixture body with the connector.
Assemble the emergency battery box and the fixture body together with nuts, then put the emergency battery into the
5
emergency battery box.
© Copyright 2021 Satco Products, Inc. 12/21 v1.3
Emergency Driver
Connector
1
Emergency Function
Luminous Flux
9W
1000lm
2
Disassemble the lens and the reflector.
4
Remove the emergency test switch from the accessory
bag. Assemble it on the emergency battery box, then
install the end cap.
Test Switch
Charging Time
Emergency Time
>24 Hours
>90 Minutes
Driver
Battery
Satco Products, Inc.
Brentwood, NY 11717