Publicité
Les langues disponibles
Les langues disponibles
3.2
appliance vent connection
REAR VENT
A.
Attach the adjustable pipe to the last section of rigid pipe. Secure with
#8 X 1/2"
screws and seal.
Self
Drilling
B.
Install the inner fl ex pipe to the appliance. Secure with a minimum of
Mill Pac
Screws
three screws and fl at washers when installing 3"/5", 4"/7" or 5"/8"
Sealant
venting, or six screws and fl at washers when installing 8"/10" or
8"/11" venting. Seal the joint and screw holes using Mill Pac sealant
(W573-0007) (not supplied).
1 1/2"
(38.1mm)
C.
Run a bead of high temperature red RTV silicone sealant (W573-
Overlap
0002) (not supplied) around the inside of the air intake collar. Pull the
adjustable pipe a minimum 2" (50.8mm) into the air intake collar.
note:
Always fi nish vent system installation with the appliance vent connection. Ensure that the sealant is not visible on the
exterior pipes once installation is completed. An optional decorative black band may be available with this appliance.
In the event that the venting must be disassembled, care must be taken to reseal the venting.
3.3
natural vent specifics
3.3.1 chimney installation
WARNING
!
•
A chimney venting this appliance shall not vent any solid fuel burning appliance.
Three types of chimney systems may be used with this appliance.
"A" VENT - SOLID
FUEL WOOD BURNING
CHIMNEY & VENT
CONNECTOR
(LINER NEEDED IF
INSIDE DIAMETER
IS 6" (152mm) OR
LARGER
SINGLE WALL OR
"B" VENT
All horizontal runs must have a 1/4" (6.4mm) rise per foot (0.3m)
3.3.2 combustion air
This appliance needs air for safe operation and must be installed in such a way that adequate combustion air is
available.
TOP VENT - FLEX
#8 X 1/2"
Self Drilling
Screws
1 1/4" (31.8mm)
Overlap
Mill-Pac Sealant
Red RTV
Silicone
MASONRY CLAY
LINED CHIMNEY +
VENT CONNECTOR
(NO NEW LINER
NEEDED IF OLD
LINER DIAMETER IS
4-5" (102-127mm)
TOP VENT - RIGID/FLEX
#8 X 1/2"
Self Drilling
INSERT
Screws
IMAGE HERE
19.2
SINGLE WALL OR
"B" VENT
39.11
installation
EN
#8 X 1/2"
Self Drilling
Screws
2" (50.8mm)
Overlap
Mill-Pac
Sealant
"B" VENT GAS
BURNING
CHIMNEY
23
W415-4006 / A / 03.01.22
Publicité
