Description Of The Remote Control - MidRone SKY 120 HD Manuel D'utilisation

CHARGING AND USE OF THE LI-PO BATTERY PACK
9. Check that the battery pack is in perfect condition before charging. If the battery appears damaged
you do not charge it to avoid damage or injuries.
10. Always use the original charger to recharge the battery. Using a non-matching charger could cause
irreversible damage to the battery and cause an accident.
11. When charging, if the charge connector is overheating, this means an excessive load and this can
cause permanent damage to the battery. Please stop charging immediately if this happens.
12. Do not leave the battery unattended while charging and do not leave load near flammable material
or in a vehicle.
13. When the drone has just finished flight, the battery temperature is higher, it is preferable to wait
for 30 minutes, and charge the lithium battery when cooled, otherwise it may damage the battery .
14. Do not short-circuit the battery polarity when connecting the charger.
15. Do not expose the battery to excessive heat, never throw it into the fire to avoid any risk of
explosion.
16. Do not dispose of the battery in domestic waste but bring it to a collection point for recycling,
please check with your local authorities about it.

DESCRIPTION OF THE REMOTE CONTROL

The drone is controlled by the supplied 2.4Ghz remote control with a range of about 80 meters depending
of the environment.
REMARKS : 1. We recommend that you familiarize yourself with the buttons of the remote before you
start using the drone. 2. Photo and Video buttons only work when the camera is equipped with a micro-
SD type memory card (not included in the package). The camera supports micro-SD cards with a
maximum capacity of 32GB. It needs fast SDHC card to allow video capture in 720P resolution.
Synchronization of the drone:
Push the left handle Up,
then put it back in the middle,
And then pull it all the way down.