Conel ASS 18VC Notice D'instruction D'origine page 19

ASS 18VC0
Charger
WARNING!
Before performing any work on the charger,
pull out the mains plug. Do not use water or
liquid detergents.
 Remove dirt and dust from the housing
with a brush or a dry cloth.
Gear
NOTE!
Do not loosen the screws on the gear head
during the warranty period. Failure to comply
with this requirement will invalidate any claims
under the manufacturer's warranty.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
NOTE!
Use only original parts supplied by
the manufacturer for replacement
purposes. The use of non-original parts will
invalidate any claims under
the manufacturer's warranty.
For other accessories, in particular cutting
accessories, please refer to
the manufacturer's catalogues.
Disposal information
WARNING!
Render disused power tools unusable by
removing the power cord.
EU countries only.
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and its incorporation
into national law, used electric power tools
must be collected separately and recycled in
an environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
Batteries should be collected, recycled or
disposed of in an environmentally friendly
manner.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be
recycled.
NOTE!
Please ask your dealer about disposal
options.
conformity
We declare on our sole responsibility that the
product described under "Technical data"
conforms to the following standards or
normative documents:
EN 62841 in accordance with the regu-
lations of the directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
CONEL GmbH
Margot-Kalinke-Straße 9 / 80929 München
01.02.2021
CONEL GmbH
Margot-Kalinke-Straße 9 / 80929 München
Exemption from liability
The manufacturer and his representative are
not liable for any damage and lost profits due
to interruption in business caused by
the product or by an unusable product.
The manufacturer and his representative are
not liable for any damage which was caused
by improper use of the power tool or by use of
the power tool with products from other
manufacturers.
19