Publicité
Les langues disponibles
Les langues disponibles
OWNERS MANUAL
CLEANING AND MAINTAIN AND STORAGE
the fuel supply disconnected.
Notices:
cleaners will damage this product.
Cleaning Burner System:
1.Remove the glass beads from the burner pan .
2. Examine the burner and its components. If dirty, clean with a soft brush and soapy water solution.
3. examine the area around the burner: any dirt or foreign material, such as spider webs or nests in
this area should be removed.
4.If it is evident that the burner is damaged, the re table must not be used.
Before Each Use
3. Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.
5. See below for proper cleaning instructions.
6. Check all gas connections for leaks.
7. Check components for any signs of damage or rust.
9. If damage to any component is detected, do NOT operate until repairs are completed.
Cleaning Surfaces:
1. Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water. 2. For stub-
born stains, use a citrus-based cleaner and a nylon scrubbing brush.3. Rinse clean with water. 4. Allow
to air dry.
Before Storing
1. Turn LP gas tank valve to "CLOSED".
2. Turn control knob to the " OFF" position. Note: A "poof" sound is normal as the last of the gas is
burned. 3. Disconnect LP gas tank per "Disconnecting LP Gas Tank" section. 4. Clean all surfaces. 5.
Lightly coat the burner with cooking oil to prevent excess rusting.CAUTION: NEVER place cover on
in a cool dry location away from children and pets.
protection from the weather.
NOTICE:If you need COVERS, please contact your local dealer.
TROUBLESSHOOTING
Problem: Burner will not light using igniter
Possible Cause 1: Electrode and burners are wet.
-Wipe dry with cloth.
Possible Cause2: Igniter battery is dead or backwards.
-Check that the AAA battery is inserted correctly in the igniter (see page 10) or replace the battery.
Possible Cause 3: Igniter Pin cracked or broken - sparks at crack.
-Call XXXXXX for technical support.
Possible Cause 4: Wire loose or disconnected. -Reference page 16, step 1, reconnect wire. Call
XXXXXX.
Possible Cause 5: Wire is shorting (sparking) between igniter and electrode. -Call XXXXXXXX for
support. Possible Cause 6: Igniter Pin not pointing at BURNER HOSE.
-turn electrode to point at BURNER HOSE.
Possible Cause 7: Bad Igniter.
-Call XXXXXXXX for support.
Problem: Burner will not light with match
Possible Cause 1: No Gas Flow.
-Check if the gas tank is empty. If empty, replace and re ll. If the gas tank is not empty, refer to "Prob-
lem: Sudden drop in gas ow" on the following page.
-
Possible Cause 2: Coupling nut and regulator not fully connected.
-Turn the coupling nut about one half to three fourths a turn, until you feel a solid stop. Do not use
tools, tighten by hand only.
Possible Cause 3: Obstruction of gas ow.
- Check for bent or kinked hose.
Possible Cause 4: Spider webs or insect nest in the Venturi.
- Clean the Venturi.
Possible Cause 5: Burner ports clogged or blocked.
-Clean the burner ports as described there.
Problem: The Fire Table emits a lot of black smoke when in use
Possible Cause 1: Hose from gas replace is pinched.
Publicité
