Bissell Natural Sweep 92N0C Serie Assemblage

Natural Sweep™
92N0C SERIES
Assembly
Your sweeper requires very little assembly.
1. Find the handle section with the connector piece.
The connector piece will connect the handle to the
base of the sweeper.
2. Screw the connector piece to the base of the
sweeper. Ensure that the connector piece is screwed
tightly to the base of the sweeper or the handle may
become loose during use.
3. Continue to assemble the handle one section at
a time by tightly screwing the threaded sections
together until you have used all sections or have
reached the desired handle height.
4. Screw the handle grip onto the threaded end
of the top handle section until secure. The storage
loop in the handle grip can be aligned as needed for
storage.
For best performance, ensure that all handle sections
are secure before using.
Emptying
To empty the dirt bins hold the sweeper over a trash
bin and pull down on the tabs on the sides of the
sweeper.
Maintaining
For best performance keep brushes and bearings
clean of hair, threads and other debris.
The sweeper case will bow slightly to allow the center
brush rolls to be removed for cleaning. To replace
brush rolls fi t the bearing to the proper axle end.
©2019 BISSELL Inc.
BISSELL Canada Corporation
Mississauga, Ontario L5N 0B3
All rights reserved. Printed in China.
Part Number 162-0225 02/19
Visit our website at: www.BISSELL.ca