Bimar FLS-120LG Notice D'instructions page 14

the device. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total current
(amps) must not be rated lower than the maximum current of the appliance.
• Before each use, check that the appliance is in good condition and that the power
cord is not damaged: if in doubt consult a qualified professional.
• The plug point must be accessible so as to easily remove the plug in case of an
emergency.
• Stand the appliance on a flat, horizontal and stable surface, and keep it away from:
- heat sources (e.g. open flames, gas stoves, etc.)
- liquids (e.g. from bathtubs, showers, sinks etc.) to avoid splashing water and to
prevent it from falling into them (the appliance should be kept a minimum of 2
metres away).
- fabrics (curtains, etc.) or floating materials/particles that may block the aspiration
grid; check also that the front part is free from floating particles (dust, etc.).
• If there is a fault or the appliance is not working correctly, switch it off and have it
checked by a qualified professional. Repairs done by an unqualified person can be
dangerous and cause the guarantee to become void.
• The appliance comes with the following parts:
Water tank (10) Is at the back. It slides out like a drawer and it is locked into place
-
with a lever (9). Add demineralised water that is limescale and additive free (no
essences, detergents or other). Do not exceed the max. level marking (approx. 4L:
running time of approx. 6 hours) or fill to below the min. level (approx. 1 litre). The
2 ice bricks provided can be added to cool the air down further after having been
frozen in a freezer for at least 10 hours.
Make sure that the water drain plug (16) is securely fastened/screwed into its seat.
Front grille: the horizontal flaps (3) can be adjusted up or down manually. The
-
vertical flaps (4), automatically swivel right and left by pressing the button on the
control panel.
Filters. These are found at the back of the appliance, secured with a frame
-
containing two screws (14): the external pre-filter (8) traps dust, fluff, etc., while
the internal filter, made of honeycomb cellulose, is sprayed with water and
thereby cools the air that passes through it.
Control panel with switches for the following functions:
-
 "
filled with: this function is most effective in drier air, and is less effective as
relative humidity increases (RH). The button starts and stops the water
pump.
within the min-max values; when the water is below the min level switch
off the cooler function.
"0" button stops both the ventilation function and the appliance. It is started

by pressing it.
" button: cools the air and evaporates micro-particles of H²O it is
The function only takes place in the presence of water in the tank,
14/40