FOCUSEAT U-AH0008R30A4ATG Mode D'emploi page 5

5. Chair back to seat assembly.
A. Remove the four screws from the seat back
using the L Shape Wrench provided. using
the L Shape Wrench provided.
B. TIP: Start with the right side of the chair
with the recliner. It is much easier to start
on this side as the mount point is fixed in
place. Do not tighten the screws down
completely until you have both sides
(all four bolts) started in the seat
back.
C. Use the screws taken from the seat back
to attach the seat cushion and the seat
back together.
5
6. Place seat assembly onto
the chair base assembly by
inserting the gas lift cylinder
into the center hole in the seat
mechanism.
A. It will slide into place. Make
sure the seat assembly is firmly
pressed down into place before
using the chair.
7. Attach the lower snap button first. Tight the
small screw into the hole on the recliner cover,
and then attach the screw cover on it.
A. There is a right and left side cover.
8. Enjoy your new FOCUSEAT
gaming chair.
6