Publicité
Les langues disponibles
Les langues disponibles
Preventing the TV from falling
1. Using the appropriate screws, firmly fasten a set of brackets to the wall.
Confirm that the screws are firmly attached to the wall.
– You may need additional material such as wall anchors depending on
the type of wall.
2. Using the appropriately sized screws, firmly fasten a set of brackets to the
TV.
– For the screw specifications, refer to "Standard Screw" in the table on
page 10.
3. Connect the brackets fixed to the TV and the brackets fixed to the wall
with a durable, heavy-duty string, and then tie the string tightly.
– Install the TV near the wall so that it does not fall backwards.
– Connect the string so that the brackets fixed to the wall are at the
same height as or lower than the brackets fixed to the TV.
Installing a sound bar (sold separately)
When you install a sound bar (3 inches or less in height) on the TV stand, attach the RUBBER-FOOTs to the bottom of
the sound bar before mounting the sound bar. Make sure that the RUBBER-FOOTs are not out of the stand width. Refer
to the figure below:
TOP
English - 12
BOTTOM
Publicité
