Ener-G+ HEA-21545 Guide D'utilisation page 3

Step 5:
Put the radiator on the bracket, fix it with the three
M6*10 screws and M6*4 nuts, then tighten them.
Step 1: Using the wall mount bracket as a template
mark the four screw holes where you plan to install the
radiator.
Step 2: Place the mounting bracket on the four marks
and tighten four screws (not included).
Ceiling mounted for concrete or very hard surfaces (screws not supplied):
Step 1: Using the hanging mount bracket as a template
mark the two holes where you plan to install the
radiator. Drill two holes into the ceiling and hammer
two expansion screws (not supplied).
Wall mounted for other surfaces (screws not supplied):
Once installed, you can tilt the radiator by loosening
the two side mounting screws and then retighten them.
Step 3: Put the radiator on the bracket, fix it with the
three provided M6*10 screws and M6*4 nuts, then
tighten them.
Step 2: Screw two screws through the square tube into
the wall and tighten.
2