Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
►
To prevent damaging the door or door gasket, make sure the door is open at least 90-degrees
when pulling shelves out of the rail compartment.
►
The door opens to a maximum of 135 degrees with a door stop on the bottom hinge preventing the
door from opening further.
Installing the Wooden Shelves
1. Open the door completely and push the shelf tracks affixed to the walls of the inner cabinet to the
rear of the unit so that the tracks are fully seated inside the cooler compartment.
2. Line up the rails affixed to the shelf with the corresponding wine cooler tracks attached to the
inner cabinet walls.
3. Push the front of the shelf inwards evenly until the shelf rests fully inside of the unit and you are
able to close the door.
4. The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start
over.
TIP: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves
out of their track.
Removing the Wooden Shelves
1. Open the door completely and remove all the contents loaded on the shelf, if applicable.
2. Pull the shelf towards yourself until it has fully extended outward
3. The shelf has plastic posts on both sides as indicated in the diagram below. While facing the unit,
press the plastic post on the right side down while pulling up on the left plastic post.
4. Evenly pull out the shelf from the track until it is completely removed from the inner compartment.
18
PRW24C32BG Use, Care, and Installation Guide
P R E S R V ™
W I N E C O O L E R
D U A L Z O N E
Publicité
