FN-114202
PARTS DESCRIPTION
1.
Clamping ring
2.
Front fan guard
3.
Blade fastening screw
4.
Fan blade
5.
Guard fastening screw
6.
Rear fan guard
7.
Motor shaft
8.
Shaft pin
9.
Oscillation knob
10. Speed buttons
ASSEMBLING INSTRUCTION
1. Rotate the blade fastening screw and guard fastening screw out of the motor shaft.
2. Put the rear fan guard on the motor shaft and screw together with the guard fastening screw.
3. Push the fan blade onto the motor shaft ensuring the blade fits properly with the shaft pin. Tighten the
blade fastening screw to fix the fan blade firmly.
4. Put the front fan guard against the rear fan guard and fix with the clamping ring. Make sure the clamping
ring is set properly at the rim of the fan guards.
5. Tighten the screw on the clamping ring.
OPERATING INSTRUCTIONS
1.
Plug the power cord into a suitable socket.
2.
Oscillation: to make the fan head oscillate, push down the Oscillation knob. To stop the fan head from
oscillating, pull up the Oscillation Knob.
3.
The fan is switched on using the push buttons on the control panel, i.e. 0: Off, 1 = low speed, 2 = medium
speed, 3 = high speed.
CAUTION: Press only one of the speed control button at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it
down with a damp cloth and then dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it
occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
Supply voltage: 220-240V ~ 50/60Hz
Power consumption: 35W
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has occurred
- 4 -
EN