Ameriwood HOME 2595342COM Livret D'instructions page 12

STEP 4
3
(x2)
Top edges of both
parts will be flush.
Be sure your parts are
positioned as illustrated.
Position and insert locking bolts (9) of left rear leg (J) into edge holes of left panel (A) as shown.
Be sure both parts are positioned as shown. Place the hammer block on top of leg in each of the 3
locking bolt locations and give a firm strike to lock together. The locking bolt (9) will snap into the
locking sleeve (8).
IMPORTANT NOTICE: Once locked together, parts cannot be seperated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
ameriwoodhome.com
Hammer Block
3
J
A
I
12
3
J
Hole(s) in
this surface.
A
End View