Publicité
Les langues disponibles
Les langues disponibles
1600A019PE.qxp_Go 4/6/18 12:22 PM Page 8
CHARGING THE TOOL
Your Dremel GO does not come completely
charged from the factory. Be sure to charge
tool prior to initial use.
- Insert USB cable 8 into USB port of power
adapter 9 (Fig. 1).
- Plug power adapter 9 into standard power
outlet.
- Open Micro USB port cover 6 and plug
micro USB plug into Micro USB port 5.
The battery charge indicator 3 indicates the
charging progress. During the charging
process, the indicator flashes green. The
battery is fully charged when the indicator
lights up green continuously.
It is normal for the handle of the tool to get
warm during charging.
Note: The tool cannot be used during the
charging process.
When the battery is fully charged, disconnect
the Micro USB end of the cable 8 from the tool
and close the cover 6.
Unplug the power adapter from the power
outlet (unless you are charging another tool).
BATTERY CHARGE INDICATOR
30%
60%
100%
IMPORTANT CHARGING NOTES
- Lithium-ion battery will hold its charge
while in storage for up to 2 years so it's
always ready when you need it.
- The charger was designed to fast charge
the battery only when the battery
temperature is between 32˚F (0˚C) and
113˚F (45˚C).
- A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced. To replace an old battery, contact
Dremel
customer
1-800-4-DREMEL. The Dremel Service
Center can install a new battery and ship it
back to you within 48 hours of receiving
your tool.
- If battery does not charge properly:
a. Check for voltage at outlet by plugging
in some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when
lights are turned off.
Charging the Tool
The battery charge
indicator 3 displays the
charge level of the
battery
for
a
few
seconds after the tool is
switched on and off.
service
at
c. Check USB terminals for dirt. Clean
with cotton swab and alcohol if necessary.
d. Check to see if USB cable is properly
connected to the tool and the power
adapter.
e. If you still do not get proper charging,
send tool and power adapter to your
Dremel Service Center.
Note: Use of power adapters or battery
packs not sold by Dremel may void the
warranty.
FCC CAUTION:
The manufacturer is not responsible for radio
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
-8-
Publicité
