Publicité
In case the inverter issues an alarm on any of the motors, the system switches off the respective motor and
tries to restart it after 2 minutes. At this stage, the display shows only a Warning. If after 3 consecutive
restarts, the motors still do not start, then the display shows an Alarm.
TEMP SETPOINT screen: showing which set point to view / modify. All screens are shown here
SETPOINT CONTR Control Set Point
SETPOINT ALR H High Alarm Set Point
SETPOINT ALR L Low Alarm Set Point
SETPOINT HEAT Heater Set Point
Select between Modbus / Display, set points or Onboard
SETPOINT SEL
Potentiometer
TEMP SEL
Select between Celsius or Fahrenheit.
Press MENU to return to the main menu.
SETPOINT CONTR: showing control set point. Temperature can be modified using the UP or DOWN buttons.
To save the new temperature, press the SET button, and an S will be shown in the display. Press MENU to
return to the TEMP SETPOINTS screen
SETPOINT ALARM H: showing high alarm set point. Temperature can be modified using the UP or DOWN
buttons.
To save the new temperature, press the SET button, and an S will be shown in the display. Press MENU to
return to the TEMP SETPOINTS screen.
Revisions Nr. 1-7 - 25.06.2023
Doc. nr. 99862504S62
16 / 24
Publicité
