Publicité
Step 11
Before fastening the DOOR to your unit, be sure the mounting screw is against
å
the stops as shown in the right diagram. If it isn't, loosen the mounting screw to
slide it against the stops. Then tighten the mounting screw.
Fasten a DOOR (F) to the RIGHT END (A). Use the screws provided in the
å
HINGES. See the next step for adjustments.
Fasten a KNOB (R) and BACKPLATE (S) to the DOOR (F). Use a BLACK 1-1/8"
å
MACHINE SCREW (Z).
Peel the BUMPERS from the BUMPER CARD (T). Stick two BUMPERS
å
on the SMALL ADJUSTABLE SHELF (H) where it comes in contact
with the DOOR (F).
Repeat this step for the other DOOR (F).
å
www.sauder.com/services
A
F
H
T
409046
Stop
Mounting
screw
Hinge
S
R
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
Z
Page 15
Publicité
