Vonyx STM3025 Manuel D'instructions page 4

OPERATION
1. CUE
Turn to select the channel you want to listen via headphones.
2. Microphone level
Adjust the volume of the microphone signal.
3. Channel 1
Adjust the final channel volume.
4. Input selector Channel 1
Press to select of the input on the respective channel. The "PHONO" setting is intended for turntables and for all other
signal sources, i.e. a CD player, use the "LINE" setting.
WARNING: Never connect line level equipment when PHONO-input is selected! Do not turn up the volume when no
turntable is connected to the PHONO input terminals.
5. Channel 2
Adjusts the final channel volume.
6. Input selector Channel 2
Press to select one of the input pairs on the respective channel. The "PHONO" setting (and inputs) is intended for
turntables; for all other signal sources, i.e. a CD player, use the "LINE" setting and inputs.
WARNING: Never connect line level equipment to the highly sensitive PHONO inputs! Do not turn up the volume
when no turntable is connected to the PHONO input terminals.
7. Channel 3
Adjusts the final channel volume.
8. LINE3/LINE4
Press to select audio source inputs line 3 or 4.
9. Channel USB
Adjusts the final channel volume of USB output.
10. Output selector
Press to select mono or stereo master output.
11. Power ON/OFF
Press button to turn on and press again to turn off.
12. Power LED Indicator
13. VU Meter
Indicate the output levels of left and right master channels
14. USB Port
15. MP3 / BT / REC Player Buttons
16. Phones Level
Adjust the volume of the headphones signal.
17. Crossfader CH1 / CH2
Adjust the fade between channel 1 and 2.
18. Talkover
Press this button for automatic lower the level of the input sources when using the microphones.
19. LED Indicator
Shows BT, USB or recording mode.
4