WorkPro W024006A Mode D'emploi page 3

Switch Between Drip-free / Drip
Press Down on the Front of the Red Button
Press Down Towards the Rear of the Red Button
Switch Between High / Low Thrust Ratio
Pull the Trigger Handle Downwards
Push the Trigger Handle Upwards
GB
Drip-free:
Drip-free setting is for applying
materials such as acrylic and silicone
which can flow fast and cause drips.
Drip:
Non-dripfree setting is for applying
materials such as construction
adhesives and cold polyurethanes
which flow slower. This mode keeps
constant pressure on the tube for
easier dispensing.
HIGH-Thrust Ratio:
The high setting is for applying
materials such as construction
adhesives and cold polyurethanes
which require high pressure to
dispense.
LOW-Thrust Ratio:
The low setting is for applying
materials such as acrylic and silicone
which require less pressure to
dispense but more material to come at
once.
3