PNI SH121 Manuel Utilisateur page 3

Warnings
» To prevent the risk of electric shock, disconnect
the general fuse of the house before starting the
installation of the switch.
» Do not carry out maintenance operations on
the switch if it is connected to the mains.
» This switch must only be installed by a licensed
electrician.
» It is important to make all connections
according to the connection diagram below.
» At the end of the assembly, make sure that the
wires are not stressed and that the screws are
well tightened.
» Do not exceed the maximum recommended
load.
Technical specifications
» Nominal voltage: 170V-240V AC
» Nominal current: max. 10A
» Maximum power: 200W/switch
User manual - 3