Publicité
Les langues disponibles
Les langues disponibles
Amplifier Owner's Manual
PROTECT
POWER
FRONT, REAR AND SUB INPUTS
Connect preamp signal cables from headunit to these inputs. The front
AND rear inputs must be used, if only the front input is used then the rear
speaker outputs will have no output signal. The Sub Input may or may not
be used see SUB INPUT SWITCH for more information.
HPF AND LPF CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs.
REMOTE LEVEL CONTROL
This port is for connecting the subwoofer remote level control. This allows
up to 20dB of volume adjustment. This is not a bass boost, it controls the
level of the subwoofer channel only. NOTE: This control is not compatible
with the Phoenix Gold LPL44 level control.
REMOTE
PROTECT
POWER
GROU ND
GROUND
+12V
This must be connected to the fused positive terminal (+12V) of the car's
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car's battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
NOTE: Visible through the plexiglass cover, a single blue power LED is located In the lower corner of all SD amplifiers.
REMOTE
X-OVER
FREQ.
BASS
5 Channel Power Amplifier
30Hz
300Hz
0dB
18dB
GROU ND
R
+ 12V
GROUND
REMOTE
+ 12V
SUB INPUT
L
SUB INPUT
S UB
FRONT
MIN
R
HPF
15Hz
250Hz
MIN
R
+ 12V
REMOTE
+ 12V
30A
SUBSONIC
10Hz
55Hz
BASS BOOST
Variable bass boost from 0 to +18dB @ 45 Hz for the subwoofer channel only.
SENS
FUSE
Used to reach maximum amplifier power with a wide variety of headunits.
SUB INPUT SWITCH
IN: Subwoofer speaker output is fed by the sub Input. If the headunit or
processor has a subwoofer low level output use this setting.
OUT: Subwoofer speaker output is fed by the front input and the sub Input is not
used. If the headunit or processor only has front and rear low level outputs use
this setting.
30A
30A
FL
SENS
BASS BOO ST
LPF
MAX
0dB
18dB
30Hz
300Hz
SENS
SENS
HPF
FR
MAX
15Hz
250Hz
MIN
MAX
FL
FUSE
30A
RL
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. Front and Rear Channel minimum
impedance is 4 ohm bridged or 2 ohm stereo. Subwoofer channel minimum
impedance is 2 ohm. Use Right + and Left - to bridge the front or rear channels,
the subwoofer channel is not bridgeable.
INPUT
L
SENS
SD800.5
R
MIN
MAX
SPEAKER
FRONT
INPUT
REAR
RL
RR
FR
SUB.
RR
SUB.
© 2011 Phoenix Gold • www.phoenixgold.com
Publicité
