TP-Link EAP225 Instructions D'installation page 8

English
2
Place the mounting bracket in the center of the
ceiling tile� Mark positions for the screw holes
and a position for the Ethernet cable hole� Drill
4 mm diameter holes for the screws and a 25
mm diameter hole for the Ethernet cable at the
marked positions�
3
Secure the mounting bracket to the ceiling tile
using pan-head screws, washers and wing nuts�
4
Feed the Ethernet cable through the hole and
set the ceiling tile back into place�
5
Connect the Ethernet cable to the Ethernet
port� Attach the AP to the mounting bracket by
aligning the arrow mark on the AP with the arrow
mark on the mounting bracket, then rotate the
AP until it is locked into place�
■ Option 2: Wall Mounting
Follow the steps below to install the AP with the provided accessories:
Note: The mounting bracket and the accessories (quantity and size) may vary by product�
6
Plastic Wall Anchors
Hole for Ethernet cable
Self-tapping Screws