TP-Link EAP225 Instructions D'installation page 9

1
If your Ethernet cable feeds through the wall,
position the mounting bracket and feed the
Ethernet cable� Mark positions for the screw
holes and then drill 6 mm diameter holes at the
marked positions�
2
Insert the plastic wall anchors into the 6 mm
diameter holes�
3
Secure the mounting bracket to the wall by
driving the self-tapping screws into the anchors�
Make sure that the shoulders of the mounting
bracket are on the outside�
4
Connect the Ethernet cable to the Ethernet port
on the AP�
5
Attach the AP to the mounting bracket by
aligning the arrow mark on the AP with the arrow
mark on the mounting bracket, then rotate the
AP until it is locked into place�
English
7