Télécharger Imprimer la page

LENCO SCD-50 BT Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2. LED indicator rapid blinking while it is pairing.
3. Pair and connect to SCD-50BT on the BLUETOOTH audio source device. If prompted for
passcode, enter "0000".
4. Pairing successful (LED indicator flashes intermittently), ready to stream music.
5. Press the PLAY/PAUSE/PAIR button to pause/resume the playback.
6. During playback, use the NEXT/PREVIOUS control knob to operate skip/search
functions as the instructions of "SKIP TRACKS AND SEARCH FOR A SPECIFIC POINT
TO PLAY (CD/MP3 DISC /USB/CARD)".
Note:
 Pairing mode is canceled about 1.5 minutes.
 The above are generic steps to pair a BLUETOOTH device, for more specific instructions
on BLUETOOTH connectivity for your device, please consult your manufacturer's
manual.
RE-CONNECT TO THE BLUETOOTH AUDIO SOURCE DEVICE
If the device is already paired with the SCD-50BT, but became unconnected even with both
Bluetooth devices turned on. You can re-connect them by following steps:
1. Press and hold the PLAY/PAUSE/PAIR button to re-link the audio source device. The
Bluetooth indicator will blink for about 1.5 minutes for connecting.
2. Select SCD-50BT on the audio source device for connecting. Bluetooth indicator will turn
to solid blue if the SCD-50BT and the device have been re-connected successfully.
AUX IN
1. Connect the audio device into the AUX in jack on the unit with a 3.5mm audio cable.
2. Power on the unit and the connected device.
3. Press the FUNCTION button to switch the unit to the AUX mode.
4. Use the native controls on the audio device to control the play.
IMPORTANT SAFETY INSTRUCTIONS
 The apparatus shall not be exposed to dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on the apparatus.
 When the AC/DC adapter is used as the disconnect device, the disconnect device shall
remain readily operable. To be completely disconnected the power input, the AC/DC
adapter shall be disconnected from the mains completely.
 No naked flame sources, such as lighted candles, should be placed on the apparatus.
 Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation
should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
 The use of apparatus is in tropical and/or moderate climates.
 Attention should be drawn to the environmental aspects of battery disposal.
 CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
 Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
 The marking plate is located at the bottom of the apparatus.
All manuals and user guides at all-guides.com
EN-5

Publicité

loading