Black & Decker BHPC220 Mode D'emploi page 6

ENGLISH
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the +
date code.
Read all of this manual carefully before
using the appliance
Only use with charger
SSC-150015 SSC-150015
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Main body
3. Cleaning pad
4. Charging station
5. Extendable pole (BHPC220 unit only)
6. Collar (BHPC220 unit only)
7. Handle (BHPC220 unit only)
6
(Original instructions)
Charging (Fig. A - B)
Securing charging station to wall
Fit the charging station (4) to a suitable wall (preferably
u
near a power outlet) using screws ( not provided) as
shown in figure A.
The unit can then be stored, when not in use, or during the
u
charging procedure as shown in figure B.
Whilst charging, the charging indicator light (8) will illumi-
u
nate.
When fully charged the charging indicator light (8) will go
u
off.
Fitting cleaning pad (Fig. C)
Place the main body of the unit (2) onto a cleaning pad,
u
ensuring that the 'loop' velcro surface located on the base
(9) engages with the 'hook' velcro surface located on the
cleaning pad (3), and press down firmly.
Switching on and off (Fig. D)
To turn the speedy scrubber on, press the on/off power
u
switch (1).
To turn the speedy scrubber off, press the on/off power
u
switch (1) again.
Fitting the collar BHPC220 unit only (Fig. E)
Place the collar (6) onto the main body (2) and press down
u
firmly, ensuring that the catch (10) clicks home securely.
To remove the collar press the catch (10).
u
Fitting the extendable pole to the collar
BHPC220 unit only (Fig. F)
Twist the Lock on the extendable pole (5) in the direction
u
of the 'unlock' position.
Allow the extension (5a) to emerge from the extendable
u
pole.
Slot the collar (6) into the extension (5a) until the button
u
(6a) clicks into position.
Twist the lock on the extendable pole (5) in the direction of
u
the 'lock' position.
Fitting handle to the extendable pole
BHPC220 unit only (Fig. F)
Slot the handle (7) into the extendable pole (5) until the
u
button (7a) clicks into position.
Adjust to desired height using the lock on the extendable
u
pole as above.
Hints for optimum use
The appliance can be used with a variety of cleaning
agents, including sprays, foams, rub-on gels and liquid
detergents.