LG LRMDS3006 Serie Manuel D'utilisation page 15

en-us_main.book.book Page 15 Wednesday, June 28, 2023 2:23 PM
Removing/Assembling
Handles
These instructions are for models which ship with
the handles assembled. For models shipped with
the handles disassembled, follow the instructions
included in the handle package.
• Tools Needed
- Units shipped with disassembled handles:
3/32" and 1/4" Allen wrenches only
- Units shipped with assembled handles:
3/32", 1/8" and 1/4" Allen wrenches
When moving the refrigerator through a narrow
opening, removing the doors is preferred. If you
must remove the handles, be very careful not to
scratch the doors.
The appearance of the handles may vary from
what is shown.
CAUTION
• When assembling or disassembling the
refrigerator handles, grasp the handle firmly to
avoid dropping it.
• Do not swing the handle into nearby people or
animals.
• Make sure that the set screws are in place and
the handle footprints at the ends of the handles
are aligned correctly over the mounting
fasteners on the doors. The set screws should be
loose enough to allow the handle footprints to
slide down into place over the mounting
fasteners on the door.
• Make sure that there is not a gap between the
door and handle after assembling the handle.
Removing Refrigerator Handles
1
Loosen the set screws
wrench and remove the handle.
2
If needed, loosen the mounting fasteners
that connect the refrigerator door and handle
using a 1/4 in. Allen wrench, and remove the
mounting fasteners.
with a 3/32 in. Allen
a
b
Assembling Refrigerator Handles
1
If needed, reassemble the mounting
fasteners on the door with a 1/4 in. Allen
a
wrench.
2
Place the handle on the door by fitting the
handle footprints over the mounting
fasteners and tightening the set screws
with a 3/32 in. Allen wrench.
Removing Freezer Drawer Handles
1
Loosen the set screws
side of the handle with a 3/32 in. Allen wrench
and remove the handle.
• For models shipped with the handles
assembled, use a 1/8 in. Allen wrench.
2
Loosen the mounting fasteners
in. Allen wrench, and remove the mounting
fasteners.
Assembling Freezer Drawer
Handles
1
Assemble the mounting fasteners
ends of the handle with a 1/4 in. Allen wrench.
INSTALLATION 15
b
located on the lower
a
with a 1/4
b
at both
a