Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
SATA to USB3.0 adapter
with HDD storage case
Item no. 55 71 93
Intended use
The adapter is used to operate an 8.89 cm/3.5" SATA hard disc (not included in the de-
livery) on a USB3.0 port. The special plastic case is not only intended for the protection
of the hard disc during operation, but it can also be used as storage box.
The external wall plug transformer enclosed is used to supply the power.
The product complies with the applicable national and European requirements. All
names of companies and products are the trademarks of the respective owners. All
rights reserved.
Package content
• SATA USB3.0 adapter
• Storage box
• Sticker for labelling the storage box
• Wall plug transformer
• USB3.0 cable
• Operating instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to
observe these safety instructions! We do not assume any liability for any
resulting damage!
We do not assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! In such
cases, the warranty will be null and void.
• The unauthorised conversion and/or modifi cation of the product is not
permitted for safety and approval reasons (CE).
• The product is not a toy. Devices operated using mains voltage do not
belong in the hands of children. Therefore, be especially careful when
children are around.
Use the product where it is out of the reach of children.
• The product is intended for use only in dry, indoor locations. No part of
the product should become damp or wet; never handle it if your hands are
wet!
Wall plug transformers have the potential to cause a fatal electric shock!
• The design of the wall plug transformer complies with Protection Class II.
Use only a standard mains socket as the power source for the wall plug
transformer.
The mains socket into which the wall plug transformer is plugged must be
easily accessible.
• Use only the external wall plug transformer supplied to power the product.
• Do not pull the wall plug transformer from the mains socket by pulling on
the cable. Hold it on the sides of the casing and pull it out of the mains
socket.
• If the wall plug transformer is damaged, do not touch it; there is danger to
life from electric shock!
First, switch off the mains voltage to the socket to which the wall plug
transformer is connected (switch off at the corresponding circuit breaker
or remove the safety fuse and then switch off at the corresponding RCD
protective switch, so that the socket is fully disconnected).
You can then unplug the wall plug transformer from the mains socket.
Dispose of the faulty wall plug transformer in an environmentally friendly
way, do not use it any more. Replace it with a wall plug transformer of the
same design.
• Do not leave packaging material carelessly lying around, since it could
become a dangerous plaything for children.
• Handle the product with care; it can be damaged by impacts, blows, or
accidental falls, even from a low height.
All manuals and user guides at all-guides.com
Inserting a hard disc into the storage box
The cover of the storage box is clipped on only. Open the cover and insert a SATA hard
disc (8.89 cm/3.5") into the storage box paying attention to the correct orientation so
that the connectors of the hard disc are located at the rear opening of the box.
Close the storage box again, so the cover snaps into place.
Driver Installation
Your operating system already contains the drivers for the hard drive enclosure, which
is why there is no enclosed disk with drivers.
Please note that a suitable USB3.0 controller is required for USB3.0 operation (e.g.
integrated in many modern motherboards or available as an upgrade using an addi-
tional plug-in card).
Connection and Operation
• Switch on your computer, if you have not yet done so, and wait until the operating
• Attach the adapter onto the terminal strip of the hard disc paying attention to the
• Place the storage box with the adapter on a fl at, level and stable surface.
• Connect the USB3.0 port on the rear of the adapter to a free USB port on your com-
• Connect the round low voltage plug from the enclosed wall plug transformer to the
• Connect the wall plug transformer to the mains voltage; plug it into a mains socket.
• Windows automatically detects the hard drive enclosure on initial start-up and com-
• Since the adapter does not have an on/off switch, disconnect the wall plug transfor-
Partitioning/Formatting the Hard Drive
• In Windows 8, Windows 7, Windows Vista or Windows XP, partitioning and format-
• After partitioning, the newly created partition has to be formatted (fast formatting is
• Only after the hard drive has been partitioned and then formatted can data be stored
If necessary, you can attach the sticker provided to the storage box and
label it.
If you have several storage boxes (one is included in the package, more
boxes are available as accessories), they can be sorted easier when they
are labelled.
system has fi nished loading.
correct orientation. Do not cant the adapter, otherwise the hard disc might get da-
maged, loss of warranty!
Protect valuable furniture surfaces by using a suitable mat to prevent scrat-
ches or pressure points.
puter using the enclosed USB3.0 cable.
Only when an USB 3.0 port is used is the fast transfer mode available; the
maximum data transfer speed for USB 2.0 or USB 1.1 ports respectively is
lower.
corresponding socket on the back of the adapter.
pletes the driver installation (the drivers are included in the operating system).
A new hard disk fi rst has to be partitioned and formatted, before the drive is dis-
played in the File Explorer and can be used (see next section).
mer from the mains voltage to switch off the adapter, unplug the wall plug transfor-
mer from the mains socket.
Afterwards, the adapter can be disconnected from the hard disc/storage box, if re-
quired.
ting can be done easily via the Control Panel (via Computer Management/Disk Ma-
nagement).
suffi cient; „normal" formatting may take a long time to complete, depending on the
size of the hard drive).
on the hard drive.
Publicité
