Publicité
Les langues disponibles
Les langues disponibles
CAUTION: Two people are required to carry this out to avoid possible damage or injury.
1. Keep the glass door closed during removal and fitting of the hinges.
2. Remove the plastic rivet (1) and top hinge cover (2) on the right side gently with a screwdriver to
expose the fixing screws.
3. Remove the top hinge screws (3) and the hinge bracket (4) on the right side (remember to hold
the glass door in place when undoing these screws).
4. Remove the glass door, then remove the plastic plug (5), and place safely aside.
5. Carefully lean the chiller backwards to an angle of approximately 60° to allow access to the bottom
hinge screws and feet. Ensure the appliance will not slip or move.
6. Remove the bottom hinge screws (7) and hinge bracket (6) on the right side.
7. Remove top hinge cover (2) and bottom foot (8) on the left side.
8. Fit top hinge cover (2) and bottom foot (8) on the right side.
9. Fit bottom hinge bracket (6) on the left side.
10. Carefully bring chiller back to the upright position.
11. Place glass door onto bottom hinge bracket and hold in place.
12. Fit top hinge bracket (4) on the left side, carefully checking the door alignment.
13. Fit top hinge cover (2) on the left side.
IMPORTANT: After changing the door direction check the door is aligned horizontally and vertically
and that the seals are closed on all sides before fully tightening the top hinge. Adjust the levelling
feet to minimize operating noises caused by vibration.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the fridge.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes
before switching back on to allow the coolant fluid to settle.
23
Publicité
