Publicité
Les langues disponibles
Les langues disponibles
WARNING — Do not store explosive substances such as aerosol cans with a flammable propellant
in this appliance.
WARNING — If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
WARNING — Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear
of obstruction.
WARNING — Do not damage the refrigerant circuit.
WARNING — Do not use electrical appliances inside the compartments of the appliance, unless
they are of the type recommended by the manufacturer.
WARNING — The refrigerant and insulation blowing gas are flammable. When disposing of the
appliance, do so only at an authorized waste disposal center. Do not expose to flame.
Refrigerant
The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance, a
natural gas with a high level of environmental compatibility, which is nevertheless flammable. During
transportation and installation of the appliance, ensure that none of the components of the refrigerant
circuit becomes damaged. The refrigerant (R600a) is flammable.
Caution risk of fire
If the refrigerant circuit should be damaged:
▪
Avoid opening flames and sources of ignition.
▪
Thoroughly ventilate the room in which the appliance is situated.
It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord
may cause a short circuit, fire, and/or electric shock.
Electrical safety
▪
We cannot be held responsible for any incident caused by poor electrical installation. The power
cord must not be lengthened.
▪
Make sure that the power plug is not crushed or damaged. A crushed or damaged power plug
may overheat and cause a fire.
▪
Make sure that you can access the main plug of the appliance.
▪
Do not pull the main cable.
▪
If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock
or fire.
▪
You must not operate the appliance without the interior lighting lamp cover.
▪
The appliance is only applied with power supply of single-phase alternating current of
220~240V/50Hz. The device uses a wall socket earthed according to current recommendations.
▪
If the power cable is damaged, do not proceed with his replacement but contact your after-sales
service.
▪
The socket must be readily accessible but out of reach of children. If unsure, contact your
installer.
▪
When positioning the appliance, ensure the supply cord is not trapped or damaged.
17
Publicité
