Power Dynamics DS50A Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL PANEL
1. AUX INPUT: 3.5mm (stereo) mini jack can be used to connect various audio sources.
2. LOOP OUTPUT: Stereo line-signal output for connecting to active speakers.
3. SUB OUTPUT: Bass output to connect to subwoofer.
4. SLAVE SPEAKER OUTPUT: Output for connecting with an active slave speaker.
POWER LED: LED indicator showing power status. When the power switch is set to 'ON',
5.
it will light up in a constant BLUE color. When the power switch is set to 'AUTO', it will light
up in a BLUE color when a signal is detected. When no signal is detected or power switch
is set to 'OFF', the light will be off.
6. RCA LINE INPUT: Stereo RCA input jacks. Connect with the output of an audio source
with line signal, such as a CD player, tape deck, etc.
7. SPEAKER INPUT: Line signal speaker input.
8. TREBLE CONTROL: Adjust the high tones/frequencies.
9. BASS CONTROL: Adjust the low tones/frequencies.
10. MASTER VOLUME: This knob controls the master volume.
11. POWER ON/OFF/AUTO SWITCH: Turn ON or OFF. When in auto position, the amplifier
will automatically turn on when a signal is detected. When no signal is detected, it will go
stand-by.
12. POWER SUPPLY: Insert the included power cord here to power the unit.
CONNECT BT
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "BT PAIR" button and activate BT-function.
2.
Select "PD DS50" on your BT-device and make the BT-connection
3.
4