Publicité
EN
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advice
• For safety purposes we strongly recommend the product to be assembled by at least two people.
• Be sure to check that there are no hidden pipes or cables in the wall before drilling.
• Some parts may have sharp edges. Please be careful when handling components. Always wear
gloves, eye protection, and long sleeves when assembling or performing any maintenance on
your product.
• Do not attempt to assemble the product in windy or wet conditions.
• Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
• Dispose of all plastic bags safely – keep them away from children's reach.
• Keep children away from the assembly area.
• When using a stepladder or power tools, make sure that you are following the manufacturer's
safety advice.
• Do not climb or stand on the roof.
• Do not hang or lay on the profiles.
• Keep roof and gutters clear of snow, dirt & leaves.
• Heavy snow load on the roof can make it unsafe to stand below or nearby.
• If color was scratched during assembly it can be fixed.
Cleaning instructions
• In order to clean the product, use a mild detergent solution and rinse with cold clean water.
• Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
• Clean the product once assembly is complete.
Before Assembly
• Choose your site carefully before beginning assembly.
• Consider the door's opening (inside or outside).
• Sort the parts and check against the content parts list.
• Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so
they do not get lost.
• Please consult your local authorities if any permits are required prior to constructing the product.
Additional information
• Please apply silicone sealant if needed
• You are solely responsible for determining whether the handling, storage, assembly,
installation or use of this product is safe and appropriate in any location or for any
given application. The manufacturer is not responsible for any damages or injury to
you, any other person or any property resulting from the improper handling, storage,
installation, assembly or use of this product, or the failure to follow the manufacturer's
written instructions regarding the handling, storage, installation, assembly and use of this
product. This product is intended for normal residential use only. Do not use this product
for any application that is not recommended in these instructions or building codes in
effect in location where this product will be used. Always take care and use appropriate
safety equipment (including eye protection) when assembling or installing this product.
During Assembly
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
• During assembly, use a soft surface below the parts to avoid scratches and damages.
Step 10: Before inserting panels and locking in place, make sure you Remove
covering plastic film from both sides of the panel.
Step 11: In order to insert the panel, push it from the below.
Step 12+13: Use scissors to cut the rubber gasket surplus.
Step 12: Assemble the rubber gasket at the bottom of the product.
Step 13: Assemble the rubber gasket above the panel at the top of the product.
* Please tighten all screws when completing assembly.
Note: The wall anchoring kit supplied with this product is suitable for concrete
or solid brick walls. Other wall types need an accordant wall fixation kit.
Publicité
