Vista
®
Towel and Wiper Dispenser
Installation Instructions
EN
Step One: Unpacking the Dispenser
1 Centerpull Towel and Wiper Dispenser
Dispenser Key
If anything is missing from the above list, please call 1-866-HELLOGP (1-866-435-5647).
Step Two: Mounting the dispenser
1. Locate the screw holes in the back plate of the dispenser
that will most reliably secure the dispenser to the wall for your application.
2. Mark location for screw holes on wall using dispenser and a tape measure.
3. Use good mounting practices to accurately pre-drill pilot holes for screws.
4. Hold dispenser to wall and ensure pilot holes align with dispenser.
5. Fasten screws to wall, leaving about ¼ inch
between the wall and screw head.
6. Ensure that dispenser is level and functional
before tightening screws to prevent dispenser
from moving.
If you are experiencing any problems with this dispenser, please call 1-866-HELLO GP (1-866-435-5647).
©2011 Georgia-Pacific Consumer Products LP. All rights reserved. The Georgia-Pacific logo, and all trademarks are owned by or licensed to Georgia-Pacific Consumer Products LP.
Centerpull
Before You Begin
TOOLS AND SUPPLIES
• Screwdriver
• Power Drill
• Pencil or Pen
• Tape Measure
• Level (recommended)
• 4 ea. 1 Inch Screws
. Choose the holes
1
1
See larger reference
illustration on page 3.