MPM MSW-11 Mode D'emploi page 9

5. After drying, set the switch
6. The hair dryer has a system to prevent overheating - in case of clogging the air outlet open-
ings it will automatically turn off and then turn on by itself after cooling.
7. During prolonged drying, it is recommended to switch off the dryer for a while.
ATTENTION! The dryer is equipped with a styling nozzle and a diffuser. The styling nozzle is used to facilitate
drying hair by directing a compact stream of air to the selected strand of hair, and the diffuser gives the
hair volume and fluffiness. Installation of accessories is done by connecting them with the dryer in the inlet
locations.
CLEANING AND MAINTENANCE
1. The dryer does not require any special maintenance. Just follow the following principles of
use.
2. For proper operation, the device should be kept clean. Do not cover the air outlet openings,
as the device can then easily overheat.
3. Always remove the plug from the wall socket immediately after finishing drying and before
cleaning.
4. From time to time, clean the dirt out of the air outlet opening with a brush.
5. The dryer's body can be cleaned with a damp cloth.
6. After finishing air drying, wait for hair to cool.
7. Do not wrap the power cord around the appliance!
SPECIFICATIONS
Power: 1800-2200 W
Power supply: 220-240 V 50/60 Hz
Noise level: L = 76 dB
WA
Power cord length: 1.7 m
WARNING! Do not use this appliance near water.
ATTENTION! MPM agd S.A. reserves the right to make technical changes.
PROPER DISPOSAL OF THE PRODUCT
Poland Marking on the product indicates that after the service-life of the product expires, it should not be disposed
with other type of municipal waste. Used equipment may have a negative impact on the environment
and health of people due to potentially containing hazardous substances, mixtures and components. Mixing
electric waste with other types of waste or disassembling those in an unprofessional manner may cause
a release of substances that are hazardous to the environment and health. Used equipment should be handed-over to
a point for collection of electric waste. In order to obtain detailed information regarding the electric waste collection points,
the user should contact the municipal point of electric waste collection or used equipment processing department.
to "0" and the switch
3
(waste electrical and electronic equipment)
to the heat-min position.
2
9