Beper P206VEN100 Mode D'emploi page 9

Stand Fan Use Instructions
Description of the item Fig.A
1. Front grid
2. Closure nut
3. Nut blades
4. Blades
5. Rear grid nut
6. Rear grid
7. Motor
8. Swing button
9. Body motor
10. Inclination set button
Assembly instructions
Put the base on the floor.
Insert the inner pole inside the outer pole.
Insert the base ornamental pin and fix the high adjustment handle.
Fix the pouter pole to the base with the 4 screws (included in packaging).
Important: firmly fasten the screws to the base in order to guarantee the good stability of the fan,
otherwise the fan will dangerously swing.
Take off the outer pole, and adjust it to the desired height. Securely fasten the high adjustment handle.
Place the control panel on the pole.
Fasten completely with the screw, so that the control panel is well fixed onto the inner pole.
Place the rear grid on the motor, so that the holes of the grid are well inserted into the motor of the fan.
Firmly and securely fasten the rear grid in order to block the grid on the motor.
Insert the blades of the fan on the motor and completely screw the nut blade on the motor, in order to block the
body motor.
Assembly the 2 grids (front and rear) by inserting the closure nut, place the front grid on the rear grid.
Close the nuts to block the grids.
Speed selection
Choose the desired speed by pressing on the buttons of the control panel.
Position 0 the fan is off.
Position 1 for low speed.
Position 2 for medium speed.
Position 3 for high speed.
When the fan is on, the night light switches on.
Head inclination
It is possible to choose various positions and change the air flow direction.
Before adjusting the inclination, switch off the fan.
Take the motor body, unscrew the regulation axis and change the inclination of the fan as desired; then fasten
firmly.
Warning: do not try to force the inclination position in order to avoid any failure.
Swing function
When pressing the swing button, it is possible to activate or deactivate the swing function, by pressing the swing
pin. Swing function provides a more even distribution of air flow in the room.
To activate the swing function, push the swing pin down until completely blocked; the head fan turns automati-
cally from right to left.
To deactivate the swing function, raise the pin completely.
Cleaning
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be slightly damp.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
11. Night light
12. Control panels
13. Screw for pipe
14. Inner pole
15. Outer pole
16. High adjustment handle
17. Base fastening screws
18. Base ornamental pin
19. Base
9
EN