Télécharger Imprimer la page

Cafe CIC36LP2VS1 Manuel D'utilisation page 9

Masquer les pouces Voir aussi pour CIC36LP2VS1:

Publicité

Les langues disponibles

Les langues disponibles

Controls
CONTROL PANEL
The control panel shows the set temperature of the
fresh food, convertible and freezer compartments.
The actual temperature will vary from the set
temperature based on factors such as door opening,
amount of food, defrost cycling and room temperature.
NOTE: Frequent door openings or a door left open for
periods of time may increase the internal temperature of
the freezer or refrigerator compartment temporarily.
Before changing the temperature, press the Zone Select
pad until you reach the zone you wish to adjust.
To change the temperature settings, press the (+) or
(-) pads to desired
Temperature Ranges
temperature set point.
Allow 24 hours for the
refrigerator to reach the
temperature you have
set.
-21°C
Changing Display Temperature From °F to °C
To change between Fahrenheit and Celsius, press and hold the Zone Select and (-) pads on the control panel for 3 seconds.
TurboCool
TurboCool™ rapidly cools the refrigerator to cool foods
food to the refrigerator, when putting away foods after
they have been sitting out at room temperature, or when
putting away warm leftovers. It can also be used if the
refrigerator has been without power for an extended
period.
Access TurboCool™ in the SmartHQ™ App to activate
the feature. The display will show tc. After 8 hours,
TurboFreeze
the SmartHQ™ App to activate the feature.
Nighttime Snack Mode
App to activate the feature.
49-10007261 Rev. 0
Preset Settings: Allow 24 hours to reach these preset temperatures.
Low
High
34°F
42°F
Refrigerator
1°C
6°C
-6°F
+4°F
Freezer
-16°C
ON
FRIDGE
DOOR
ALARM
TOP
OFF
For the Convertible Drawer,
touch, only a single tap is necessary to switch between
each preset zone.
Convertible Drawer Preset Zones:
Freezer (sync with freezer)
Meats 29°F (-2°C)
Drinks 33°F (1°C)
Snacks 37°F (3°C)
To turn off the cooling system press and hold both (+)
and (-) pads for 3 seconds. Once complete, the display
will show COOOLING OFF.
To turn the cooling system on, press either (+) or (-)
pad and the display will show COOLING ON.
NOTE: Setting the controls to COOLING OFF stops
cooling, but does not shut off electrical power to the
refrigerator.
or if TurboCool™ is deactivated through the app, the
refrigerator will return to the original setting.
NOTE: The refrigerator temperature cannot be changed
during TurboCool™. The freezer temperature is not
the refrigerator door during TurboCool™, the fans will
continue to run if they have cycled on.
9

Publicité

loading

Ce manuel est également adapté pour:

Cic36Cip36