Publicité
Les langues disponibles
Les langues disponibles
Figure 11
6. Reinstall the glass lens in place by inserting the two tabs
connected to the light lens into the holes in the grill and
applying upward pressure until the lens fits snugly into
place (Figure 12).
Figure 12
7. Restore power and test your installation.
210572064 Rev. A 8-05
Get user manuals:
See SafeManuals.com
Lamp Holder
Night Light
Hole
SECTION 7
Use and Care
CAUTION:
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Refer to instructions in Section 6
Completing the Installation , to remove grill and glass light
lens. Use a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR
SCOURING POWDERS. Completely dry all parts before
reinstalling. Refer to instructions in Section 6 Completing the
Installation , to reinstall grill and glass light lens.
2. Cleaning the Fan Assembly: Unplug the motor cord and light
cord from receptacles and loosen the venturi screw to remove
the venturi from the unit. Wipe all parts with a dry cloth or
gently vacuum the fan. NEVER IMMERSE ELECTRICAL PARTS
IN WATER. Refer to instructions in Section 6 Completing the
Installation , to reinstall venturi.
Lens
CAUTION:
3. Changing the Light Bulb: Disconnect power to the unit.
Remove the glass light lens from the grill by pulling downward
on the lens. It is held in place with hidden tabs on either side
of the lens. It might be necessary to carefully insert a putty
knife or screwdriver into one of the indentations around the
light lens to help release the lens from the grill (Figure 9).
Replace main light bulb with 100 watt maximum, type A19
medium base incandescent bulb. Replace night light bulb
with 7 watt maximum, type C7 (candelabra base)
incandescent bulb. Reinstall the glass lens in place by
inserting the two tabs connected to the light lens into the
holes in the grill and applying upward pressure until the
lens fits snugly into place (Figure 12).
www.airkinglimited.com
MAKE SURE POWER IS SWITCHED OFF AT
ALLOW BULB TO COOL BEFORE REPLACING
4 of 12
Publicité
